Specification :

Function:
Measure the signals of automotive sensors
1 .The most complete hand held diagnostic tester for sensors,wiring,connectors
and on-board computers
DC voltage,lambda,frequency and pulse signals can be measured
2.Digital display shows actual output of signals
3.Measures any voltage AC or DC,resistance or frequency output
Allows Simulation of most Sensor and computer managemeng omponents
4.Simulating temperature sensors,throttle potentiometers,switches,air
flow meters and lembda/oxygen srnsors
5.Features AC voltage output to simulate vehicle speed sensors(vss),
CAM,CRANK,and ignition reluctors
6. Simulates actual working condition of any sensor without having to remove it
from the vehicleA.B.S.,Crank,Can,Coolant,Oxygen,MAP,MAF,MAT,VSS,etc
Cheeks basic ECU operation
7. Controlling the signals being produced allows you to check ECU response and
operation.This prevents mis-diagnosis where the fault may lie in the ECU itself
or in the wiring between the component and the ECU.Works independently or with
any scan tool ever made
Can be used on any domestic or import vehicle
Eliminates unnecessary replacement of non-defective sensors
Can drive computer into"open or closed loop."

Specifications:
Simulate Signal Range Function
DC Voltage 0-1V Simulating lambda/oxygen sensors
0-5V Simulating DC signal of sensors
0-12V
Resistance 0-5K Simulating temperature or resistance sensors
0-200K
Frequency SignalV/Duty/Hz 0-5v 10-90% 10-4KHz Simulating frequency signal sensors
0-12V 10-90% 10-4KHz

Test Function Range Basic Accuracy
DC Voltage 400mV,4v ,40v,400v,1000v (0.5%+3d)
AC Voltage 400mV,4v ,40v,400v,750v (0.8%+3d)
DC Current 40mA,400mA,10A (1.2%+3d)
AC Current 40mA,400mA,10A (1.5%+3d)
Resistance(O) 400,4K,40K,400K,4M,40M (1.0%+3d)
Capacitance 40nF,400nF,4uF,40uF,100uF (5.0%+3d)
Frequency 10Hz-10MHz (0.5%+3d)
Duty cycle 0.1%-99.9% (2.0%+3d)
Diode test and Audible Continuity test Test current:1±0.6mA
>60O Buzzer sounds