Combidek, smartdek, Bondek , deking[Nov. 25, 2010 1:41:44]
Specification
Assembly instructions
sheet must be mounted with the narrow tops facing upwards, ( see figure at bottom right) .sheet covering is 870 mm
joining
sheet must be joined with overlaps above bearing supports.Overlapping is preferable, since joint need not be sealed to prevent leakage . if sheet are mounted adge -to-adge with hout overlapping the joints must be sealead with sealing strip or L- profile. L- profile is suittable eg, ehen sheets meet each other at an angle bearing length must be at least 50mm.greater bearing length may be necessary in some cases. There is a risk for collapse if the bearer and/ or joint is inavertently shifteed during pouring
213e2d5c
