Specification :

Overview
PS-CON02 E1 to Ethernet converter is a high-performance self-study remote Ethernet bridge, which has small volume and low cost and is very ideal to the bridge connection application occasion needing cheapness. It can also be used as the LAN extender. The objective of PS-CON02 type Ethernet E1 interface converter is to implement the interconnection of Ethernet through E1 link, and E1 interface can be set to control the rate of network interconnection.E1 terminal of PS-CON02 type Ethernet over E1 converter can be set as two kinds of modes: non-framing and framing; the 2Mb/s interface of framing mode supports the rate of N¡�64Kb/s (N=1-31), and the 2Mb/s interface non-framing mode supports the rate of 2048Kb/s.

Main Characteristics£º* Adopt large scale chip, simple circuit, low power dissipation and high reliability, which can
fully replace the network bridge from 10BaseT to single E1* Provide one 10/100M Base-T port, support 10/100M full duplex , half duplex and automatic negotiation
mechanism
* Provide one E1 digital interface, and impedance:75¦¸/120¦¸* Support 802.1p priority function* Support VLAN Ethernet frame transparent transmission
* Provide one management interface, which can flexibly set functions of equipments
* Have the complete alarm and status indication* Adapt to many kinds of power supply environments

Indexes of power supply:  DC power supply voltage: -48VDC; tolerance range: -36V~-72V; power supply ripple:¡Ü240mVp-p AC power supply voltage: 220VAC¡À20% 50HZ; power dissipation: ¡Ü10W * Indexes of Ethernet interface: Physical interface type£ºRJ-45  Interface specification: conform to IEEE-802.3u standard  Interface rate: 10/100M self-adaptive Network bridge parameter: the filtering and transmitting rate reaches 15,000 frames per second  256-frame buffer  10,000 MAC address LAN table  Self-study and update function  Increased Tiny Gram compressed mode * E1 electrical interface
Number of sub-circuit: one  Nominal rate: 2048Kbps, tolerance¡À50ppm  Interface code pattern £ºHDB3 Interface impedance: 75¦¸ (imbalance)  Electrical characteristics of digital interface: conform to ITU-TG703 suggestion  Input jitter tolerance: conform to ITU-TG.823 suggestion  Input jitter: conform to ITU-TG823 suggestion  Level £º¡À2.37V¡À10% Interface connector: BNC or CC4 (75¦¸)* Management interface characteristics  Interface mode:RS-232 Interface level:RS-232 level  Physical interface:RJ-45 * Operation Environment  Working environment: environmental temperature: 0¡æ~45¡æ; relative humidity: ¡Ü85%ý(35¡æ) Atmospheric pressure: 86-106Kpa
* External dimensions: 200¡�145¡�35mm
Instructions for DIP Dial Switch
    Dial switch (SEL): when the equipment parameters are set as the dial switch configuration, the dial switch is effective. MSEL is used to select the maximal packet length that the Ethernet can pass through. The selective maximal packet length for ON is 1518/1522; the selective maximal packet length for OFF is 1536/1536. TSEL is used to select the clock of transmission E1line; OFF adopts the local clock to select the transmission of E1 line; ON adopts the restored clock to select the transmission of E1.