EOBD Galleto Flasher 1260

Quantity Order:

Detailed Description
EOBD Galleto Flasher 1260
Features Specifications:
Update 1250 to 1260
The Gallettto 1250 ecu flashing tool covers a large amount of vehicles and can read data from your engine control unit , The data contains MAPS which are responsible for ignition advance, injection timing, torque limiter, speed limiter and more. By reading the data and using a Editor program like WinGal 32 b you can find these MAPS and alter the values to optimize and improve the power of the newest modern vehicles.DescriptionWithin the engine systems, the ECU uses a closed-loop control system to monitor the outputs of a system in order to control the inputs to a system on managing the emissions and fuel economy of the engine ( as well as a host of other parameters) . It gathers data from dozens of different sensors and knows everything from the coolant temperature to the amount of oxygen in the exhaust gas. With these data, it performs millions of calculations each second, including looking up values in its tables, calculating the results of long equations to decide on the best spark timing and determining how long the fuel injector should open. The ECU does all of these to ensure the lowest emissions and best mileage achieved for the car.
FunctionsThis GALLETTO 1250 ecu flasher can be used to read and write flash dumps of the most recent ECU' s. It is very easy to operate through Notebook / PC with USB port.
RestrictionsBackup of the ECU memory is not supported for some of the listed ECUs in the manual. Some ECUs can not be flashed over the OBDII connector in the car, in this case you have to remove the ECU from the car and flash it on the desk.Reading data from the engine control unitTurn ignition on to pos II ( Just the ignition only , Not the engine) select the ECU you want to read/ write from a listselect additional options ( if needed) click the read button to read the original data ( where supported) save the file to you Hard drive for editing .How to write data to a supported ecuConnect the hardware to your usb port & to the diagnostic port of the car , ( Not all cars support reading/ writing over the diagnostic port) start the communication softwareturn ignition on to pos II ( Just the ignition only , Not the engine) select the ecu you want to read/ write from a listselect additional options ( if needed) click the write button and select the file you want to writefollow the instructions on screenswitch off ignition and wait 10 seconds done.

Recommend to your friends